Chute limit switch lead

Diagram

The chute limit switch lead, x1 per machine. The buildable
sub-harness for LIM on the LED drops and limit switch
drawing. Nothing on it is soldered: two crimps at the
board, two push-on tabs at the switch.
%3 BOARD BOARD Dupont 1x3 female, 2.54 mm 3-pin GND 1 SIG 2 +3V3 3 Additional components 2 x #4 (Terminal - Dupont crimp, 2.54 mm) basically board v1.3 J5, the header printed HALL_SW_0. Position 1 is the cavity at the moulded arrow. Position 3 carries no contact: it lines up with the 3.3 V pin, which is what stops the housing going on backwards. J6 beside it is a spare input, not this one. LIM LIM 2x 22 AWG 24.0 in   BOARD:1:GND     1:BK     SW:1:GND BOARD:2:SIG     2:WH     SW:2:SIG   qty 1. Two conductors, black ground and white signal. BOARD:e--LIM:w BOARD:e--LIM:w SW SW Quick-connect receptacle, #187 4.75 x 0.5 mm tab, insulated 2-pin 1 GND 2 SIG Omron V-155-1C25. The switch is SPDT and its third tab stays bare. LIM:e--SW:w LIM:e--SW:w

Bill of Materials

Id Description Qty Unit Designators
1 Cable, 2 x 22 AWG 24 in LIM
2 Connector, Dupont 1x3 female, 2.54 mm, 3 pins 1 BOARD
3 Connector, Quick-connect receptacle, #187, 4.75 x 0.5 mm tab, insulated, 2 pins 1 SW
4 Terminal - Dupont crimp, 2.54 mm 2 BOARD